Home Products

PRESTO SIGMA UCAB232 Other products Museum

Electronic Design Sales & Prices Support About us Contact

PRESTO supports wide range of devices:

• Microchip PIC^®, dsPIC/PIC24^® and PIC32^® MCUs
  Serially programmable (all Flash and the most popular OTP/JW)
  Supported by: program UP.
• Atmel AVR^® and 8051 architecture MCUs
  Devices with SPI low voltage serial downloading - for example ATtiny12, AT90S8535, ATmega128 and AT89S51
  Supported by: program UP.
• 32-bit ARM-based MCUs by various vendors
  Programming and debugging using OpenOCD, programming of selected parts also directly by the ASIX' ARMINE application, e.g. Atmel AT91SAM7xxx. More about ARM support...
  Supported by: program ARMINE.
• Texas Instruments MSP430^® MCUs
  (Security Fuse blowing is not supported).
  Supported by: program UP.
• Chipcon (now Texas Instruments) CCxxxx^® MCUs
  Supported by: program UP.
• Cypress PSoC^® MCUs
  CY8U21xx, CY8U24xx and CY8U27xx.
  Supported by: program UP.
• Components with JTAG interface
  - types which can be programmed using SVF or XSVF file - for example
  • CPLDs - Xilinx (XC95xx, CoolRunner, ...), Altera, Lattice and others
  • FPGA configuration Flash PROMs - Xilinx (XC18Vxx, XCFxxS)
  • Atmel ATmega
  Supported by: JTAG SVF Player.
• Serial EEPROM and Flash memories
  
  • I²C (24LCxx)
  • Microwire (93LCxx)
  • SPI EEPROM (25Cxx)
  • SPI Flash EPROM (M25Pxx, M45PExx, ...)
  Supported by: program UP.
• Cyan Technology eCOG1
  Including basic debug control via eICE interface (Run, Stop, Reset).
  Supported by: eCOG Programmer.

The  → complete list of devices supported by the program UP  with comparison chart for all ASIX programmers.

Note for low-voltage versions of Microchip parts: The programming algorithm for the PIC...LF... devices is the same as for the PIC...F... devices. So, when you need to program e.g. the PIC18LF2420 chip, select the PIC18F2420 device.

If you need to program a device not listed here, please contact us and, if PRESTO is able to support the device, we will implement it. Addition of any part manufactured by the vendors listed above is free in most cases, sometimes we will charge you a moderate fee.